I am installing a DFF3D/2KW chirp combo transducer.
No problems with the DFF3 side but having problems when connecting the 30-60 Hz & 80-130 Hz parts of the 2KW transducer.
Cable is 18-472-22 rev.02
Cable is labeled as follows-
Blue/White wire = Low (+) Depth
Shield wire
Black/White wire = Low (-) Depth
Blue wire = High (+) Depth
Shelid wire
Black wire = High (-) Depth
White wire = Temp
Shield wire
Brown wire = Temp, XIDT ground
Orange wire = XIDT
Overall shield wire
The interconnect diagram in the DFF3 manual is using what I think is different terminology.
Any suggestions on where to connect would be appreciated.
No problems with the DFF3 side but having problems when connecting the 30-60 Hz & 80-130 Hz parts of the 2KW transducer.
Cable is 18-472-22 rev.02
Cable is labeled as follows-
Blue/White wire = Low (+) Depth
Shield wire
Black/White wire = Low (-) Depth
Blue wire = High (+) Depth
Shelid wire
Black wire = High (-) Depth
White wire = Temp
Shield wire
Brown wire = Temp, XIDT ground
Orange wire = XIDT
Overall shield wire
The interconnect diagram in the DFF3 manual is using what I think is different terminology.
Any suggestions on where to connect would be appreciated.